Gerber EDGE FX Owner's Manual page 18

12 CHAPTER 2
Installing the GERBER EDGE FX
2 Press F4, SYSTEM to display the SYSYEM MENU.
3 Press F1, NETWORK to display the NETWORK MENU.
4 Press F1, TCP/IP to display the TCP/IP MENU where you can change the IP Address
of the GERBER EDGE FX.
5 Press F1, IP ADDR. to open the IP ADDRESS MENU where you change the IP address.
The designates which octet (three digit section of the address ranging from 000 to
–––
255) is available to be changed. Use F4, NEXT to move the active designation to the
octet that you wish to update.
6 Use the Left or Right Slew keys to change the value of the octet. Press F4, NEXT to
move the active designation to the next octet and change that value. Continue until the
entire IP Address is updated.
Note: This procedure uses the default IP address of the GERBER EDGE FX as an example.
Your IP address for the printer may be different.
7 Press F1, SAVE to set the displayed IP Address. The display changes to:
Continue with step 8. The address will be active after cycling the printer
after reboot.
power at the end of the procedure.
8 Press F3, CANCEL to leave the IP Address Menu and return to the SYSTEM MENU.
SYSTEM MENU
F1 NETWORK
F2 DIAG
NETWORK MENU
F1 TCP/IP
F2 ETHERNET
TCP/IP MENU
F1 IP ADDR.
F2 SUBNET MASK
IP ADDRESS MENU
F1 SAVE
F2 –––
169 . 254 . 128 . 129
CANCEL F3
MOTION F4
CANCEL F3
F4
CANCEL F3
DHCP F4
CANCEL F3
NEXT F4
IP Address used