Chapter 2: Getting Started; Unpacking And Setting Up The Plotter; Connecting The Data And Power Cables - Gerber ODYSSEY XP Owner's Manual

4 CHAPTER 2
Getting Started
Chapter 2:
Getting Started
This chapter contains the steps you need to prepare the plotter for
cutting:
♦

unpacking and setting up the plotter

♦

connecting the data and power cables

♦
turning on the plotter
♦
adding the ODYSSEY XP to the cutting software
♦
loading material
♦
installing tools
♦
changing knife blades
♦
adjusting knife blade exposure
Unpacking and setting up the plotter
The ODYSSEY XP is shipped from the factory in reusable packaging
materials. Included with the plotter is the booklet ODYSSEY XP
unpacking, assembling, and repacking instructions. Follow these instructions
to unpack the plotter, assemble the stand, and mount the plotter on the
stand. Save the packaging materials and instructions in case you need to
ship the plotter in the future.
Connecting the data and power cables
The ODYSSEY XP is supplied with a serial cable and power cord. They
plug into the plotter at the left rear corner (when you are facing the
front).
To connect the data and power cables
1 Connect the 25-pin connector end of the serial cable to the connector
on the plotter and tighten the screws.