Setting The Ip Address And Network Mask Of Your Computer For Direct Connection - Gerber EDGE FX Installation Manual

18 CHAPTER 3
Connecting the GERBER EDGE FX to the Computer
11 Press F2, SUBNET MASK to open the SUBNET MASK MENU where you can change
the Subnet mask of the printer. The
changed. Use F4, NEXT to move the active designation to the octet you wish to update.
12 Use the Left or Right Slew keys to change the value of the octet. Press F4, NEXT to
move the active designation to the next octet and change that value. Continue until the
entire Subnet Mask is updated.
13 Press F1, SAVE to set the displayed Subnet Mask. The display changes to:
used after reboot.
14 Press F3, CANCEL to exit the menu and return to the MAIN MENU.
15 Cycle the power to the GERBER EDGE FX. The network address will be active after
cycling the printer power.
Setting the IP Address and Network Mask of your computer for direct
connection
If you need to change the network address of you computer that is directly connected to the
GERBER EDGE FX, follow the procedure for your Windows operating system (Windows 98 SE,
Windows XP, or Windows 2000). These procedures use the following address for the computer:
♦ Computer IP address: 169.254.128.130
♦ Computer Network Mask: 255.255.0.0
To set the IP Address and Network Mask for Windows 98 SE
1 Click Start > Settings > Control Panel.
2 Double-click the Network icon.
3 Click the Configuration tab.
4 Click TCP/IP.
designates which octet is available to be
–––
SUBNET MASK MENU
F1 SAVE
F2 –––
255 . 255 . 000 . 000
CANCEL F3
NEXT F4
Subnet Mask