Gerber EDGE FX Owner's Manual page 36

30 CHAPTER 3
Material and Foil Handling
4 Position the plastic strip with the RFID identifier label so that it rests between the rolls
of the Foil Insert.
Note: Do not touch the surface of the foil. Oils from your hands can damage it. Always handle
the foil by the end plugs only.
5 Holding the end plugs only, lift both of the Foil Insert rolls from the Foil Blister
Package. Insert the front roll of foil into the slots at the front of the Foil Caddy. (The
end caps have different diameters that match the size of the slots.)
6 Gently pull the rear roll toward the back of the Foil Caddy, making sure that the
plastic strip with the RFID label remains on top of the roll.
7 Insert the rear roll into the rear slots in the Foil Caddy. Rotate the end caps to tighten
the Foil Insert so that the foil is free of wrinkles and does not droop. Loose foil can get
caught in the EDGE FX cartridge loader.
8 Rotate the plastic strip with the RFID label toward the rear of the Foil Caddy. The strip
should snap into slots on both sides and position the RFID label so that it shows
through the open window at the back of the Foil Caddy. The EDGE FX reads the RFID
identifier label to determine the foil color and remaining usable length.
Note: If the label is not positioned correctly in the window, the EDGE FX will not be able to
identify the foil and you may not be able to close the Foil Caddy.
9 Close the Foil Caddy ensuring that both front latches are secured and the Foil ID Card
is visible. If you encounter resistance, the foil end caps may not be seated properly in
the slots, or the RFID strip is obstructing the closure.
Plastic strip with RFID label
Snap the plastic strip with the RFID label into the slots