Reestablishing Factory Default Settings - Gerber EDGE FX Owner's Manual

Reestablishing factory default settings

Factory default settings are restored by pressing and holding the F3 and right slew key during
power-up. Following is a chart of the factory default settings.
Setting Default Value
Ethernet xx-xx-xx-xx-xx-xx
Address
(MAC
Address)
DHCP 0.0.0.0
Server
IP Address 169.254.128.129
Network 255.255.0.0
Mask
Gateway 0.0.0.0
DNS Server 0.0.0.0
Overlap 15 lines
SysLog xxx.xxx.xxx.xxx
Address
Language English
Cover Enabled
Sensors
Out-of- Enabled
vinyl
Sensor
Range Description
valid Unique 6 byte address assigned by IEEE.
Ethernet This address is a factory default cannot be
address changed. Also known as the MAC Address
(media access control).
valid IP IP address of DHCP (dynamic host
address configuration protocol) server. The default
setting is 0.0.0.0 for none.
valid IP IP address of GERBER EDGE FX. Enter a
address unique IP address for network to which the
GERBER EDGE FX will be physically
connected.
valid Network mask for your network.
network
mask
valid IP IP address of network gateway (if one
address exists). The default setting is 0.0.0.0.
valid IP IP address for DNS server (if one is
address available). The default setting is 0.0.0.0 for
none.
5 - 25 Specifies the number of lines to re-print
when printing resumes after a PAUSE or an
ERROR (e.g. foil error).
valid IP Address of the network syslog server. If not
address 0.0.0.0, all messages logged in the printer's
syslog buffer are also sent to the network
syslog server at this IP address.
English Front panel messages are displayed using
the selected language. All web pages except
for diagnostic pages are displayed in
selected language.
enabled Cover sensors can be disabled to allow the
disabled printer to continue printing with a non-
functioning sensor.
enabled Out-of-Vinyl Sensors can be disabled to
disabled allow the printer to continue printing with a
non-functioning sensor.
67