Gerber EDGE FX Owner's Manual page 37

Foil ID Card
10 Save the Foil Blister Package to store the Foil Insert when not in use. When unloading
the Foil Caddy, remember to return the Foil ID Card to the slot in the Blister Package
so that it is available the next time you assemble a Foil Cartridge.
To disassemble the EDGE FX Foil Cartridge
1 Depress the latches on either side of the Foil Caddy and open the lid 180º until it lies
flat on a table or counter.
2 Open an empty Foil Blister Package and set the Blister Package on the table beside the
Foil Caddy (lids facing away).
3 Remove the Foil ID Card from the Foil Caddy and insert it in the slot in the Foil Blister
Package so that the foil name is visible from the outside.
4 Rotate the plastic strip with the RFID identifier label forward so that it rests between
the rolls of the Foil Insert.
Note: Do not touch the surface of the foil. Oils from your hands can damage it. Always handle
the foil by the end plugs only.
5 Holding the end plugs only, lift the front roll of the Foil Insert from the Foil Caddy and
roll it toward the rear roll. Make sure that the plastic strip with the RFID label remains
on top of the rolls.
6 Holding the end plugs only, remove the rear roll from the rear slots in the Foil Caddy.
7 Transfer the Foil Insert into the empty Foil Blister Package and close the lid.
Rotate the plastic strip with the RFID label forward
31