Table of Contents
Advertisement
3 The GERBER EDGE FX reads the RFID tag and compares it to the job requirements. If
the incorrect foil is loaded the GERBER EDGE FX alternates the message between
Need foil requested and length needed
Note: If you have the Foil Display/Speed setting set to Name only, the foil length required will
not display. For details, see "Changing the Foil Display/Speed" on page 53.
4 Remove the loaded cartridge and load the correct foil. If the printer is in Continuous
mode, it automatically begins printing. If in Single mode, press F1, OK to confirm that
the correct foil is loaded and to start printing. If you wish to substitute a different foil
see "Substituting a different foil" on page 44.
5 If the length of foil remaining on the roll is inadequate for the job, the GERBER EDGE
FX displays
Need foil requested and length needed
The foil name and the length alternate on the bottom line of the display.
on roll.
FOIL MENU
F1
OK
F2
Need ProcPro Cyan
6 Remove the loaded cartridge and load a cartridge with an adequate amount of foil.
7 When a correct foil cartridge with an adequate amount of foil is loaded the GERBER
EDGE FX displays:
FOIL MENU
F1
OK
F2
Have ProcPro Cyan
and
Have foil installed and length remaining on roll.
FOIL MENU
F1
OK
F2
Need ProcPro Cyan
CANCEL
MOTION
CANCEL
MOTION
CANCEL
F3
MOTION
F4
and
Have foil installed and length remaining
FOIL MENU
F3
OK
F4
Need 33 inches
FOIL MENU
F3
OK
F4
Have 45 inches
43
CANCEL
F3
MOTION
F4
CANCEL
F3
MOTION
F4
Hide quick links:
Advertisement
Table of Contents
