Setting The Ip Address And Subnet Mask Of Your Computer - Gerber InkJet Printer Owner's Manual

Chapter 3
Setting up the Gerber CAT | UV
8 Click the Change Settings button to accept the new values.
9 The printer prompts you power-cycle the system in order for it to update and utilize
the newly entered values.

Setting the IP Address and Subnet Mask of your computer

When using Fixed network settings, the default IP address of the Gerber CAT|UV is
192.168.000.050 and the default Subnet mask is 255.255.255.000. The following procedure uses
192.168.000.001 for the computer's IP address and 255.255.255.000 for the Subnet mask. Use the
procedure that matches your configuration: Windows® Vista, Windows 7, or Windows XP.
CAUTION: Use care when entering addresses for the equipment. Entering incorrect
addresses could damage the network. In a large existing network, obtain the correct
addresses for the computer and the Gerber CAT|UV from the network
administrator or IT Professional.
To set the IP Address and Subnet Mask for Windows Vista and Windows 7
NOTE: You must be logged on as an Administrator to configure network settings in Windows
Vista or Windows 7.
1 Click Start > Control Panel to open the Control Panel dialog box. Your display might
look different if you are in Classic View. You can switch between Classic and Category
View under Control Panel Home on the left side of the window.
2 Click Network and Internet to open the Network and Internet dialog box.
P83173A RevA
7/19/10
29