Loading A Foil Cartridge Into The Gerber Edge Fx - Gerber EDGE FX Owner's Manual

42 CHAPTER 5
Operating the GERBER EDGE FX
5 Press F2, ACCEPT to accept the substitution and F3, CANCEL to cancel the material
substitution and return to the FOIL MENU.

Loading a foil cartridge into the GERBER EDGE FX

GERBER EDGE FX foil cartridges carry RFID tags that identify the type of foil and amount
remaining on the roll. Once the foil cartridge is loaded, the GERBER EDGE FX compares the job
requirements with the loaded foil cartridge. If the printer is in Continuous mode and the correct
foil and length is loaded, the printer continues automatically. If the printer is in Single mode
you must press F1, OK to continue printing. If the foil is different than requested by the job or
the length is inadequate, the GERBER EDGE FX notifies you via the LCD and allows you to
make substitutions.
Tip: Assemble all of the foil cartridges required for the job so that they are ready when you
need them.
To load an assembled foil cartridge into the GERBER EDGE FX
1 After loading the material into the GERBER EDGE FX the foil loading prompt
displays. The first foil needed for the job and the required length alternate on the
bottom line of the display.
Note: If you have the Foil Display/Speed setting set to Name only, the length required will not
display. For details, see "Changing the Foil Display/Speed" on page 53.
2 Remove the assembled foil cartridge from its protective sleeve and slide it into the
GERBER EDGE FX with the dull side of the foil facing down, as shown in the
following photo.) Push the cartridge all the way into the printer. The GERBER EDGE
FX beeps one time when the foil cartridge is loaded correctly.
Substitution OK?
F1
F2 ACCEPT
FOIL MENU
F1 OK
F2
Need ProcPro Cyan
CANCEL F3
F4
CANCEL F3
MOTION F4