Unpacking And Installation; Unpacking And Removing The Metal Fixings - Canon NP6330 Service Manual

CHAPTER 9 INSTALLATION
II. UNPACKING AND INSTALLATION
Bringing in a metal object from a cold to warm place can cause droplets of water on
its surface. This phenomenon is known as condensation, and copiers subject to
condensation can generate blank copies.
If condensation is expected, leave the copier without unpacking it for 1 hour or more,
and start the installation work after it has become used to the room temperature.
A. Unpacking and Removing the Metal Fixings
No.
1
Unpack the copier, and remove the
plastic sheets.
2
Working in a group of three, hold the
copier's grips, and place the copier on
the pedestal.
Note:
Before placing the copier on the
pedestal, check to make sure that
the pedestal has been properly
installed according to its Installation
Procedure.
Note:
When the copier is lifted, always
use the handles and don't use the
left and right dummy covers.
Open the cardboard box that comes
3
with the copier, and take out the parts
and materials.
4
Remove the external taping, and slide
out the cassettes. Remove the
cushioning materials from inside the
cassettes, and slide in the cassettes.
9-2
Work
COPYRIGHT © 1997 CANON INC.
Checks/remarks
Check to make sure that two cassettes
are set inside the copier.
Grip
Grip
Left dummy
cover
Note:
If the INCH configuration copier, the
copyboard cover isn't attached.
Check to make sure that none of the
following is missing:
• Copy tray
• Operator's Manual
• Drum unit
• Power cord (220 / 240 V only)
• Lower right cover
• Screw for original tray (2pcs.)
• Original tray
• Cassette size label (inside the
cassette)
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Grip
Grip