Canon NP6330 Service Manual page 93

6) Install the scanner cable plate to the No. 1 mirror mount with the cable fixing screw
(front: 2, rear: 4) through the long hole in the side plate (both front and rear).
Note:
If you cannot remove the tool pin smoothly after the work, check the gap between
the No. 2 mirror and the mirror positioning tool; then, tighten the screw on the No.
1 mirror mount as necessary once again.
COPYRIGHT © 1997 CANON INC.
(rear)
Figure 3-523
Figure 3-524
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 EXPOSURE SYSTEM
3-29