J Dc Power Supply Pcb; Removing The Dc Power Supply Pcb - Canon NP6330 Service Manual

J. DC Power Supply PCB

1. Removing the DC Power Supply PCB

1) Remove the three screws
motor driver 1 PCB
2) Disconnect all connectors from the DC power supply PCB.
3) Remove the four screws
COPYRIGHT © 1997 CANON INC.
, and disconnect the six connectors
together with its mount.
Figure 7-427
, and remove the DC power supply PCB
Figure 7-428
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 CONTROLS AND EXTERNALS
; then, remove the
.
7-25