Canon NP6330 Service Manual page 15

GENERAL DESCRIPTION
This chapter describes the outline of the features, how to operate and copying process
of this copier.
I. FEATURES.........................................1-1
II. SPECIFICATIONS ..............................1-2
A. Copier ............................................1-2
B. Paper Deck Pedestal-M1 ..............1-8
III. NAMES OF PARTS ............................1-9
A. Exterior View .................................1-9
B. Cross Section ................................1-11
IV. OPERATION.......................................1-13
A. Control Panel (AB/Inch).................1-13
B. Control Panel (Inch) ......................1-14
C. User Mode .....................................1-17
V. ROUTINE MAINTENANCE
BY THE USER ...................................1-20
COPYRIGHT © 1997 CANON INC.
CHAPTER 1
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
VI. IMAGE FORMATION..........................1-21
A. Outline ...........................................1-21
B. Static Latent Image Formation
Block..............................................1-23
C. Pre-Exposure (step 1) ...................1-23
D. Primary Charging (step 2) .............1-24
E. Image Exposure (step 3) ...............1-24
F. Development (step 4) ....................1-25
G. Transfer (step 5) ............................1-26
H. Separation (step 6)........................1-27
I. Fixing (step 7)................................1-28
J. Drum Cleaning (step 8) .................1-28
VII. AUXILIARY PROCESS ......................1-29
A. Blank Exposure .............................1-29