Installing the riser-card assembly
To install the replacement riser-card assembly, complete the following steps:
1. Install any adapters and connect any cables you might have removed in other
2. Carefully align the riser-card assembly with the retention latches, the guides on
3. Install the cover (see "Installing the cover" on page 40).
4. Slide the server into the rack.
5. Connect the cables and power cords.
6. Turn on all attached devices and the server.
Access holes
procedures.
the rear of the server, and the riser-card connector on the system board; then,
press down on the assembly. Make sure that the riser-card assembly is fully
seated in the riser-card connector on the system board.
Release tabs
Chapter 3. Removing and replacing server components
85