Installing the power backplane
To install the replacement power backplane, complete the following steps.
1. Align the edge-connector of the power backplane with the power-backplane
2. Slide the power backplane toward the left side of the server until the
3. Connect the power cable from the hard disk drive backplane to the power
4. Install the fan-bracket assembly (see "Installing the fan-bracket assembly" on
5. Install the cover (see "Installing the cover" on page 40).
6. Install the power supplies into the power-supply bays (see "Installing a hot-swap
7. Slide the server into the rack.
8. Connect the cables and power cords.
Power backplane
connector
edge-connector on the system board.
edge-connectors are fully connected.
backplane.
page 67).
power supply" on page 69).
Chapter 3. Removing and replacing server components
83