2.5-inch drives
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Move the handle on the drive to the open position (perpendicular to the drive).
3. Pull the hot-swap drive assembly from the bay.
4. If you are instructed to return the hot-swap drive, follow all packaging
Installing a hard disk drive
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this chapter.
For information about the type of hard disk drive that the server supports and other
information that you must consider when installing a hard disk drive, see the User's
Guide on the IBM Documentation CD.
To install the replacement drive in a hot-swap bay, complete the following steps.
3.5-inch drives
Important: Install only SAS or SATA 3.5-inch hard disk drives in this server.
Filler panel
on page 35
instructions, and use any packaging materials for shipping that are supplied to
you.
Hard disk drive
Tray handle
Chapter 3. Removing and replacing server components
53