Removing The Serveraid Sas Controller - IBM x3655 - System - 7985 Service Manual

3. Rotate the free end of the adapter down under the tabs and onto the pins on
4. Replace the riser-card assembly (see "Installing the riser-card assembly" on
5. Install the cover (see "Installing the cover" on page 40).
6. Slide the server into the rack.
7. Connect the cables and power cords.
8. Turn on all attached devices and the server.
9. Restore the backup copy of the configuration to the Remote Supervisor Adapter
Note: When you start the server for the first time after you install a Remote
Supervisor Adapter II SlimLine, the start-up process will take several minutes longer
than a typical start-up.

Removing the ServeRAID SAS controller

Attention:
handle the clips gently.
Note: The following illustration shows removing a ServeRAID-8k SAS controller;
the ServeRAID-8k-l SAS controller does not have a battery.
RAID controller
To remove the ServeRAID SAS controller, complete the following steps:
50
IBM System x3655 Type 7985: Problem Determination and Service Guide
the retainer brackets; then, press the adapter into the connector on the riser
card and make sure that all the tabs on the latch brackets secure the adapter in
place.
page 85)
II SlimLine. If you do not have a backup copy of the configuration, see the
documentation that comes with the Remote Supervisor Adapter II SlimLine for
information about installing the firmware and configuring the options.
To avoid breaking the retaining clips or damaging the connectors,
Battery
Battery cable
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 35.
Battery mounting
tabs
Battery mounting
clips
Battery cable
connector