Installing The Battery - IBM x3655 - System - 7985 Service Manual

11. Remove the battery:
12. Dispose of the battery as required by local ordinances or regulations. See

Installing the battery

The following notes describe information that you must consider when replacing the
battery in the server.
v You must replace the battery with a lithium battery of the same type from the
v To order replacement batteries, call 1-800-426-7378 within the United States and
v After you replace the battery, you must reconfigure the server and reset the
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
To install the replacement battery, complete the following steps:
72
IBM System x3655 Type 7985: Problem Determination and Service Guide
a. Use one finger to push the battery horizontally out of its housing.
b. Lift the battery from the socket.
"Battery return program" on page 186 for more information.
same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call you IBM marketing representative or authorized reseller.
system date and time.
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Insert the replacement battery:
a. Hold the battery in a vertical orientation so the smaller side is facing the
housing.
b. Place the battery into its socket, and press the battery toward the housing
until it snaps into place.