Installing The Riser-Card Assembly; Removing An Adapter - IBM System x3650 Type 7979 Problem Determination And Service Manual

Installing the riser-card assembly

To install the riser-card assembly, complete the following steps.
1. Reinstall any adapters and reconnect any cables you might have removed in
2. Carefully align the riser-card assembly with the release tab posts, the guides on
3. Install the cover (see "Installing the cover" on page 91).
4. Slide the server into the rack.
5. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing an adapter

This topic describes removing an adapter from a PCI slot. To remove a Remote
Supervisor Adapter II SlimLine, go to "Removing a Remote Supervisor Adapter II
SlimLine" on page 101. To remove the ServeRAID SAS controller, go to "Removing
the ServeRAID SAS controller" on page 102.
98
IBM System x3650 Type 7979 and 1914: Problem Determination and Service Guide
Access holes
other procedures.
the rear of the server, and the riser-card connector on the system board; then,
press down on the assembly. Make sure that the riser-card assembly is fully
seated in the riser-card connector on the system board.
peripheral devices and the server.
Guide
Release tabs
Guide