Network Element Profile - Cisco WS-C3550-12G User Manual

Network Element Profile

Network Element Profile
The Network Element profile sets up a standard template for the Network Element object attributes listed
below. These attributes are discussed in detail in the
on page
•
•
•
•
•
Network element profiles are created using the Network Element Management Profile window.
To launch the Network Element Management Profile window, perform one of the following:
•
•
The following figure is an example of the Network Element Management Profile window.
Figure 12-1 Network Element Management Profile Window
Using this window you can perform the following tasks:
•
•
Cisco Catalyst Switch Manager User Guide
12-2
5-4.
System Location
System Contact
Telnet Password
Enable Password
SNMP Trap Enabled
Right–click a Site object within the Network or Physical containment views, then choose
CSM/7600 Manager > NE Config/Mgmt Profile.
Right–click a Network Element object within the Network or Physical containment views, then
choose NE Config/Mgmt Profile.
Creating a Network Element Profile
Applying a Network Element Profile
Chapter 12
"Network Element Management Window" section
Profile Management
OL-4930-01