Configuration Tab; General; Layer; Private Vlan Edge - Cisco WS-C3550-12G User Manual

GE-WAN Interface Management Window

Configuration Tab

The following areas are available on the Configuration tab of the GE-WAN Interface Management
window:
•
•
•
•
•

General

The General area provides the following information:
•
•
•
•
•
Note
•
Note

Layer 2

The Layer 2 area provides the following information:
•
•
Cisco Catalyst Switch Manager User Guide
8-32
General
Layer 2
Layer 3

Private VLAN Edge

Actions
Duplex—Displays the duplex mode for the port. This attribute is read–only and should have one of
the following values:
– full-duplex
– half-duplex
Max. Input Queue Length—Displays the input queue length in packets.
Max. Output Queue Length—Displays the output queue length in packets.
Link Up/Down Trap—Indicates if link up or link down traps are being generated. This list contains
the following values:
enabled
–
disabled
–
Delay—Specifies the delay in tens of microseconds for an interface or network segment.
The Delay attribute is an informational parameter used only to communicate the current delay
to the higher-level protocols (such as IGRP and EIGRP); you cannot adjust the actual delay of
an interface with this command.
Bandwidth—Overwrites default bandwidth in kilobits per second.
The Bandwidth attribute is an informational parameter used only to communicate the current
bandwidth to the higher-level protocols (such as IGRP, EIGRP, and OSPF); you cannot adjust
the actual bandwidth of an interface with this command.
MAC Address—Displays the MAC address of the interface.
MTU—The size, specified in octets, of the largest datagram (frame) that can be sent on the interface.
Chapter 8 Interface and Subinterface Management
OL-4930-01