Named Aggregate Tab; Conform Action - Cisco WS-C3550-12G User Manual

QoS Management – Configuration Window

Named Aggregate Tab

The Named Aggregate tab describes the named aggregate policers defined globally on the device. The
following area is available on the Named Aggregate tab of the QoS Management - Configure dialog:
Conform
Note The Named Aggregate tab is inactive for Cisco Catalyst 2950 series devices and is not supported in
Hybrid OS.
In addition to this area contains the following information attributes:
•
•
•
•
Note

Conform Action

The Conform Action area contains the following information:
•
•
Cisco Catalyst Switch Manager User Guide
9-26
The QoS Management—Add Policy window consists of the following:
Policy Map Name—Indicates the name of the QoS policy map policy instance to be added to
–
the device.
Add—Adds the configured QoS policy map policy instance to the device.
–
Action.
Named Policers table—Lists by aggregate name the named aggregate policers defined globally on
the device. This table displays the following:
Aggregate Name—Unique identifier of a named aggregate policer on the managed device.
–
Rate—Maximum transmission rate (in bits per second) to enforce against policed traffic.
Burst—Normal burst size in bytes to enforce against policed traffic.
Max. Burst—Maximum burst size in bytes to enforce against policed traffic. A value of 0 indicates
that a maximum burst size has not been specified. This field is inactive when a Cisco Catalyst 3550,
4000, or 4500 series device is selected.
The Max. Burst feature is not supported in 12.1(8a)E and earlier.
Conform Action—Action to be taken when traffic conforms to QoS parameters. This attribute has
one of the following values:
– Drop—Drops packet
– Transmit—Transmits packet
– Set DSCP—Assigns DSCP value to packet before it is transmitted.
Set Precedence—Assigns IP Precedence value to packet before it is transmitted.
–
A value of none (0) indicates no conform action has been specified.
–
This field is inactive when a Cisco Catalyst 3550 device is selected.
Set DSCP—Integer DSCP value assigned to packets of conforming ingress traffic before
transmitting on egress interfaces. This value is only relevant and will only be set in the running
configuration of the device if the Conform Action attribute is Set DSCP.
This field is inactive when a Cisco Catalyst 4000 or 4500 series device is selected.
Chapter 9 Software Management
OL-4930-01