Cisco WS-C3550-12G User Manual page 83

Chapter 4 Deploying the Cisco Catalyst Switch Manager
Figure 4-5
Step 2 Specify the passwords and SNMP communities as follows:
a. Select the Configuration tab on the Network Element Management window.
b. In the CLI Passwords section, specify the Telnet Password and Enable Password parameters as
follows:
–
–
Specify the SNMP read and write community strings as follows:
Step 3
Select the SNMP Access tab on the Network Element Management window.
a.
Enter the correct SNMP read/write community strings as follows:
b.
–
–
–
OL-4930-01
Network Element Management window
Telnet Password—Password used to connect to the switch using the Telnet protocol.
Enable Password—Password used to enter the enable mode on the switch.
All values entered in these text fields will be displayed as "*".
SNMP Version—The version of the SNMP agent running on the switch. The version is one of
these values: SNMPv1, SNMPv2c, or SNMPv3.
The SNMPv3 value is not supported by the Catalyst switches.
SNMP v2c Read Community—The v2c community string used to read data from the agent.
SNMP v2c Write Community—The v2c community string used to write data to the agent.
Enabling Communication Between Network Elements and Devices
Cisco Catalyst Switch Manager User Guide
4-23