Status Tab; Interface Status - Cisco WS-C3550-12G User Manual

ATM/E3 Interface Management Window
The following tabs are available on the ATM/E3 Interface Management window:
•
•
•
•
•
•

Status Tab

The following areas are available on the Status tab of the ATM/E3 Interface Management window:
•
•

Interface Status

The Status area provides the following information to describe the general characteristics of the
interface:
•
•
•
•
•
Cisco Catalyst Switch Manager User Guide
8-84
Status Tab
Configuration Tab
ATM/E3 Tab
Performance Tab
Routing Protocol Tab
Additional Notes Tab
Interface Status
Performance Logging
Description—Comment or a description to help you remember what is attached to this interface. The
description is only put in the configuration to help you remember what specific interfaces are used
for.
Index—String index of the interface. This attribute is read-only.
Operational Status—The current operational state of the interface. This attribute is read-only. This
attribute has one of the following values:
testing—Indicates that no operational packets can be passed.
–
– unknown
– down
– up
– dormant—Interface is waiting for external actions (such as a serial line waiting for an incoming
connection)
– notPresent—Interface has missing (typically, hardware) components.
lowerLayerDown—The interface in the lower layer is down.
–
Administrative Status—The desired state of the interface. This attribute has one of the following
values:
testing (read-only)—Indicates that no operational packets can be passed.
–
up
–
down
–
Last Change—The value (in seconds) of sysUpTime at the time the interface entered its current
operational state. If the current state was entered prior to the last reinitialization of the local network
management subsystem, then this object contains a zero value. This attribute is read-only.
Chapter 8 Interface and Subinterface Management
OL-4930-01