Client Side Vlan Tab; Client-Side Vlan; Client Vlan Config; Gateway Config - Cisco WS-C3550-12G User Manual

SLB Module Management Window

Client Side VLAN Tab

The following areas are available on the Client Side VLAN tab of the SLB Module Management
window:
•
•
Client–Side VLAN
The Client Side VLAN area provides the following information:
•
•

Client VLAN Config

The Client VLAN Config area allows the user to add client side VLANs. The following attributes are
configured:
•
Note
•
•

Gateway Config

The Gateway Config subarea allows the user to add a default gateways associated with the client VLAN
specified in the Client Side VLAN field. This VLAN must already be configured as a client side VLAN.
•
•
Cisco Catalyst Switch Manager User Guide
7-22

Client-Side VLAN

Client VLAN Config
Client–Side VLAN Table—Identifies the client VLANs used by the CSM. These are the VLANs on
the device to which clients will connect. The following attributes are displayed for the selected client
VLANs in the table:
IP Address—IP address of the client VLAN.
–
Netmask—Subnet mask of the client VLAN IP address. Enabled bits indicate network
–
addressing bits in the IP address.
Client–Side VLAN Gateway Table—Describes the default gateways associated with the client
VLANs. There may be multiple gateways associated with each client VLAN. The following
columns are displayed in this table:
Client Side VLAN—Unique identifier of a client VLAN on the device.
–
Gateway—Default gateway of a client VLAN. A router to the client VLAN must have this
–
gateway address configured and real servers must point their gateways to this address.
Client Side VLAN—Unique identifier of a client VLAN on the device.
VLAN 1 is the default VLAN. VLAN identifiers greater than 1001 are reserved as the default
VLANs for various media and for hidden VLANs generated by the device.
Client VLAN Add—Adds the client VLAN specified in the client side VLAN field. If you do not
specify a VLAN in the Client Side VLAN field, no action will take effect.
Client VLAN Remove—Removes the client VLAN that is selected in the Client VLAN Table. A
dialog box appears, asking you to confirm the action.
Gateway—Default gateway associated with the client VLAN.
Gateway Remove—Removes the default gateway specified by the Gateway field and the Client Side
VLAN field. You need to specify a VLAN in the Client Side VLAN field and an IP address in the
Gateway field for the action to take effect.
Chapter 7 Module and Port Adapter Management
OL-4930-01