Cisco WS-C3550-12G User Manual page 97

Chapter 5 Network Element Management
–
Note
Configure—Launches the Chassis Management - Configure SNMP Trap Client window for
•
modifying the Trap Client list.
Figure 5-3
The SNMP Trap Client Configure window provides the following:
–
–
–
–
–
Note
OL-4930-01
Notification Layer - Indicates the level at which the SNMP trap client is defined. The level is
one of these values:
layer2Only—SNMP trap client is defined on the datalink layer only.
•
layer3Only—SNMP trap client is defined on the network layer only.
•
layer2And3—SNMP trap client is defined on the datalink and network layers.
•
The IP address of the Cisco EMF server host should be in this list at all times. If it is not, then
Cisco EMF will not receive any traps from the switch or router, which might result in an event
being reported in an untimely fashion or an event being missed.
Chassis Management—Configure SNMP Trap Client Window
SNMP Trap Client Address—The IP address to which SNMP traps are sent.
SNMP Trap Client Community String—The community string used within the SNMP trap.
SNMP Version—The SNMP version running on the device, snmpv1c or snmpv2.
Add Client—Adds a client to the client list.
Remove Client—Removes the client from the client list.
An error is reported if a nonexistent client is removed or if an existing client is added.
Network Element Management Window
Cisco Catalyst Switch Manager User Guide
5-9