Chapter 4: Setting Up And Connecting The Wireless-G Bridge For Phone Adapters; Starting The Setup Wizard; Running The Setup Wizard; Figure 4-1: Welcome Screen - Cisco Linksys Wireless-G WBP54GV2 User Manual

Bridge for phone adapters
Table of Contents

Advertisement

Wireless-G Bridge for Phone Adapters
Chapter 4: Setting Up and Connecting the Wireless-G
Bridge for Phone Adapters
To configure the Bridge, run the Setup Wizard on the CD enclosed with the Bridge. This chapter and the Setup
Wizard will guide you through the installation procedure.
IMPORTANT: Do not connect the Bridge until you are instructed to do
so or the setup will not work.

Starting the Setup Wizard

To begin the setup process, insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup Wizard should
run automatically, and the Welcome screen should appear. If it does not, click the Start button and choose Run.
In the field that appears, enter D:\setup.exe (if "D" is the letter of your CD-ROM drive).
On the Welcome screen, you have the following choices:
Click Here to Start or Setup - Click the Click Here to Start or Setup button to begin the software installation
process.
User Guide - Click the User Guide button to open this User Guide.
Exit - Click Exit to exit the Setup Wizard.

Running the Setup Wizard

1. To install the Bridge, click the Click Here to Start button on the Welcome screen.
2. After reading the License Agreement, click Next if you agree and want to continue the installation, or click
Cancel to end the installation.

Chapter 4: Setting Up and Connecting the Wireless-G Bridge for Phone Adapters

Starting the Setup Wizard

Figure 4-1: Welcome Screen

Figure 4-2: License Agreement Screen

7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Linksys wireless-g wbp54g

Table of Contents