Lucent Technologies MERLIN LEGEND Release 6.1 Installation Manual page 320

MERLIN LEGEND Communications System Release 6.1
Installation 555-661-140
Upgrading the System
Upgrading from the MERLIN II Communications System
Replace old modules and add new modules as specified on the
Control Unit Diagram of Form 1, System Planning.
See "Installing the Control Unit" in Chapter 2 if you need instructions.
Install the Release 4.0 processor module in the carrier.
See "Installing the Processor" in Chapter 2.
Perform a frigid start (System Erase) to ensure that system
programming is returned to default values.
Use
button) twice
See Maintenance and Troubleshooting for more information on System
Erase.
Program the system.
Restore the system programming from a system programming
disk or Translation Memory Card (Release 3.0 and later only), if
available.
See "Restoring from the System Programming Disk" or "Restoring
from the Translation Memory Card," in Chapter 7.
If a disk or memory card is not available, see System
Programming for details on programming the system.
If applicable, program new features.
See System Programming for detailed programming procedures.
from the SPM Maintenance menu:
00
Issue 1
August 1998
Page 9-19
(Line 5, left