Lucent Technologies MERLIN LEGEND Release 6.1 Installation Manual page 261

MERLIN LEGEND Communications System Release 6.1
Installation 555-661-140
Initializing and Testing the System
Testing the System
Coverage Test
To verify that coverage is in effect, follow the steps below:
Have someone call the covered telephone.
Count the number of rings at the covered telephone before the
covering telephone starts ringing.
This should be the same as the programmed number of rings.
Pick up the handset at the covering telephone and verify that you
have good two-way communication.
Hang up the handset at the covering telephone.
Check both Individual and Group Coverage.
Testing the DSS
At each Direct Station Selector (DSS), check that all lights are
operational. Then use the DSS to call a telephone in the system. Test
the Page buttons on the DSS.
Testing Night Service
To test the Night Service feature on the system operator console, follow
the steps below:
At the system operator console, press the Night Service button.
If Night Service with Outward Restriction is programmed, you must also
enter the password. (You can also activate Night Service on a DLC by
pressing the Feature button and dialing
The Night Service LED turns on.
Pick up the handset and press a button for an outside trunk.
Dial the outside number that reaches an operator console that is
programmed to receive Night Service coverage.
.)
Issue 1
August 1998
Page 7-16