Ground-Start Button - Lucent Technologies MERLIN LEGEND Release 6.1 Installation Manual

MERLIN LEGEND Communications System Release 6.1
Installation 555-661-140
Initializing and Testing the System
Testing the System
Figure 7-1. Ground-Start Button
To test PFT jacks, follow the steps below:
Plug a touch-tone or rotary dial telephone into a PFT jack.
Note the outside line number assigned to the lowest line/trunk jack
on the module and be sure that the outside trunk is connected to
the system.
Turn off power to the control unit.
Follow the procedure in "Powering Down the System" in Chapter 9.
If the telephone is connected to a GS trunk, push the GS button
attached to the telephone.
Pick up the handset on the touch-tone or rotary dial telephone.
You should hear a dial tone.
If the telephone is connected to a GS trunk, push the GS button
attached to the telephone again.
Dial an outside number—make sure someone can answer the call.

Ground-Start Button

Issue 1
August 1998
Page 7-20