Lucent Technologies MERLIN LEGEND Release 6.1 Installation Manual page 266

MERLIN LEGEND Communications System Release 6.1
Installation 555-661-140
Initializing and Testing the System
Testing the System
After the call is answered and you have verified that you have good
two-way communication, give the person the telephone number
assigned to the outside line bridged by the PFT jack to which you
are connected.
This is the number noted in Step 2.
Have that person call the number after you hang up.
Your phone should ring after the caller completes dialing the number.
Answer the phone and verify that you have good two-way
communication. Hang up.
Repeat Steps 1, 2, and 4 through 10 to test all PFT jacks.
Turn the power back on.
Follow the procedure in "Powering Up the System" in Chapter 2.
Testing Touch-Tone Receivers
The 400 (L/S), 400 GS/LS, and 016 (T/R) modules each provide four
touch-tone receivers (TTRs). The 008 OPT module, 800 DID module,
012 T/R module, and 800 GS/LS-ID modules each provide two TTRs.
To test TTRs, follow the steps below:
Pick up the handset of a touch-tone single-line telephone that is
connected to an 012, 016 (T/R), or 008 OPT module.
Dial
you want to test.
You should hear a busy tone if the receiver is in use, or a reorder tone if
you misdialed or addressed a receiver not in your system. (This can
happen if you dialed
one 400 (LS) module, for a total of six TTRs.)
If you hear reorder tone, try again.
If you hear dial tone after one to three seconds of silence, proceed with
this test.
and the 2-digit number (starting with 01) of the TTR that
and your system has only an 012 module and
Issue 1
August 1998
Page 7-21