Quick Reference Guide To Administration Procedures - AT&T MERLIN 3070 Administration Manual

Quick Reference Guide to Administration Procedures

This chart summarizes the administrative procedures described on pages 17 through 27. For more information about
a procedure, refer to the page listed.
Before you perform any of these procedures, enter administration mode by following the steps below.
Set switch A on the Processor Module in the control unit to Administer (down),
Insert the administration mode button labels (see the back of this manual) in the administrator/attendant console.
Slide the T/P switch on the left side of the console to P.
When you finish administering your system, leave administration mode by following the steps below.
Slide the T/P switch to the center position.
Set switch A on the Processor Module to Attendant (up).
Remove the administration mode button Iabels from the console and insert the regular call-handlilng lables used
by the attendant.
Procedure
PERFORM BASIC ADMINISTRATION
Assign or remove lines on in-
dividual voice terminals
(See page 20.)
Specify Touch-Tone or rotary
signaling for each line in your
system.
(See page 19.)
Assign PBX/Centrex exten-
sions to line buttons.
(Attendant consoles only)
(See page 22.)
Program PBX/Centrex dial
sequences onto fixed feature
buttons.
(See page 23.)
Assign call restrictions to
voice terminals.
(See page 20.)
Touch
Then
Dial the voice terminal's intercom number.
Adm Tel
Touch the line buttons.
Steady green on = line assigned
Green off = line removed
Adm Opt Dial 3.
Touch the line buttons.
Steady green on = Touch-Tonesignaling
Green off =
Dial 1.
AdmOpt
Touch the line button.
Dial the PBX/Centrex extension.
Adm Opt Dial 2.
Touch the fixed feature button.
Dial the PBX/Centrex dial sequence.
Touch Call Rstr.
Adm Tel
Steady green on = all calls permitted
Flashing green = PBX/Centrex extensions and MERLIN
Green off = MERLIN intercom calls only
rotary signaling
Intercom calls only
67