Table of Contents
Advertisement
C
H
A
P
T
E
LOCATION
Main Menu
Configure VLAN
(if switch is in Default Mode)
460T Ch5 - Sec 1-Nav & Config.p65
R
5
Using Local Management
Configure VLAN Operation Mode
Description
This screen allows you to activate or change the type of VLAN operating
on the switch. If there are no VLANs active on the switch, this is the first
screen displayed when you select Configure VLAN from the Main Menu.
By default, VLANs are not active on the Express 460T switch so they must
be turned on before you can start configuring them.
The Express 460T supports only a single type of VLAN operating at a
time. However, you can have multiple VLANs of the same type.
Select the type of VLAN: Press z to change the type of VLAN on
the switch. The Express 460T Switch supports three types of VLANs: Port-
based, MAC-based, and IEEE 802.1Q (tag-based) VLANs.
APPLY: Makes the changes to the VLAN active and reboots the switch.
Note: In order to change between VLAN types the switch must be
rebooted.
To change VLAN modes
1 Select Configure VLAN from the Main Menu.
2 Select VLAN Operation Mode from the Configure VLAN menu.
3 Press z to change the type of VLAN on the switch. Press e.
4 Select the APPLY button and press e. This reboots the switch and
changes the VLAN mode.
83
4/19/00, 4:16 PM
83
Advertisement
Table of Contents
