Table of Contents
Advertisement
C
H
A
P
T
E
R
4
Web Device Manager
Configuring the Switch's IP Settings
Note: You must select Manual in the IP Assignment Method box before you
can change the IP settings.
1 Click the Configure Device menu and then click IP Settings. The IP
Settings screen appears on the right side of the Web Device Manager
window.
2 To manually configure the IP settings, select Manual in the IP
Assignment Method box. Under "Change," type the new IP address,
subnet mask, and default gateway. If you have set up tag-based VLANs
on the switch, you can specify the VID of the VLAN where the switch's
SNMP management agent will reside.
3 To apply the changes, click Submit.
4 Click Save and Reboot for the new settings to take effect. Rebooting the
switch temporarily interrupts network connectivity to the switch. Click
Reboot Later if you want to reboot the switch later. The new IP settings
will not take effect until the switch reboots.
35
Advertisement
Table of Contents
Need help?
Do you have a question about the ES460MSX - Ethernet 1000Base SX Switch Module and is the answer not in the manual?