System Fan Assembly; Removing The System Fan Assembly - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual
Hp xw4600 workstation - service and technical reference guide
Hide thumbs
Also See for Xw4600 - Workstation - 2 GB RAM:
- Service and technical reference manual (176 pages) ,
- Specification (73 pages) ,
- Quickspecs (68 pages)
Table of Contents
Advertisement
3.
Remove the four screws from the back panel (1).
Figure 5-19
4.
Slide the power supply toward the front of the chassis and lift it out of the chassis (2).
NOTE:
To replace the power supply, reverse the previous steps.
System fan assembly
This section describes how to remove the system fan assembly.
Removing the system fan assembly
To remove the system fan assembly:
1.
Disconnect power from the system
access panel
ENWW
Removing the power supply
(Predisassembly procedures on page
(Removing the side access panel on page
57) and remove the side
61).
Removing and replacing components
71
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
