Copying A Setup Configuration To A Single Workstation - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

Copying a setup configuration to a single workstation

CAUTION:
target workstations are not the same model. For example, do not copy the setup configuration from an
HP xw4200 Workstation to an HP xw4600 Workstation.
1. Select a setup configuration to copy, and then reboot the workstation.
2. As soon as the workstation powers on, press and hold the
Setup (F10) Utility. If necessary, press
NOTE:
and then press and hold the
If you are using a PS 2 keyboard, you may see a keyboard error message—disregard it.
3. If you are using a diskette or other storage device, insert it now. If not, proceed to the next step.
4. Select File>Replicated Setup>Save to Removable Media. Follow the instructions on the screen
to create the configuration diskette.
5. Power off the workstation you are configuring and insert the configuration diskette into the diskette
drive.
6. Power on the workstation you are configuring.
7. Press and hold the
Enter to bypass the title screen.
8. Select File>Replicated Setup>Restore from Removable Media, and then follow the instructions
on the screen.
9. Restart the workstation when the configuration is complete.
ENWW
A setup configuration is model-specific. File system corruption can result if source and
If you do not press the
F10
F10 key until you enter the Computer Setup (F10) Utility. If necessary, press
Enter to bypass the title screen.
F10 key at the appropriate time, you must restart the workstation,
key again to access the utility.
F10 key until you enter the Computer
Workstation management 35