2.
Open the PCI card retention clamp. Press the retention clamp levers down to unsnap, and then
rotate them up (1).
Figure 5-31
3.
Remove the PCI slot cover (2).
4.
Align the keyed components of the PCI card with the slot , and then firmly seat the card in the slot
(3).
5.
Close the PCI retention clamp by rotating the clamp downward and pressing the two green clamp
levers from the rear panel of the chassis (4).
IEEE-1394 card (optional)
This section describes how to remove an IEEE-1394 card.
Removing an IEEE-1394 card
To remove an IEEE-1394 card:
1.
Disconnect power from the system
access panel
(Removing the front bezel on page
82
Chapter 5 Removal and replacement procedures
Installing a PCI card
(Predisassembly procedures on page
(Removing the side access panel on page
65).
57), remove the side
61), and then remove the front bezel
ENWW