Installing An Optical Drive (Minitower Configuration) - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

4. After removing the optical drive (1), if you plan to install another drive, remove only the four guide
screws from the drive casing (2).
Figure 5-39

Installing an optical drive (minitower configuration)

1. Disconnect power from the system
access panel
(Removing the front bezel on page
2. Insert the four black metric M3 guide screws into the drive casing (1).
Figure 5-40
3. Align the screws with the grooves in the drive bay, and then gently slide the drive into the
workstation until it snaps into place (2).
ENWW
Removing the optical drive screws
(Predisassembly procedures on page
(Removing the side access panel on page
65).
Installing the optical drive
57), remove the side
61), and then remove the front bezel
Removing and replacing components 89