Replacing The Side Access Panel - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

WARNING!
powered off and that the power cord is disconnected from the electrical outlet.
1. Disconnect power from the system
2. Unlock any locks that may be present (cable lock or padlock).
3. Pull open the access panel handle (1).
Figure 5-7
4. Slide the access panel toward the rear of the workstation and lift off the cover (2).

Replacing the side access panel

To replace the side access panel:
1. Place the access panel over the chassis and align the tabs along the edges of the access panel
with the slots in the chassis.
2. Press the access panel down, fitting the tabs into the slots.
3. Slide the access panel toward the front of the chassis until it locks into place.
Figure 5-8
62 Chapter 5 Removal and replacement procedures
Before removing the workstation side access panel, be sure that the workstation is
Removing the access panel
Installing the access panel
(Predisassembly procedures on page 57).
ENWW