Installing A Sas Hard Drive - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

Installing a SAS hard drive

1. Disconnect power from the system
the side access panel
2. Attach a SAS-to-SATA cable adapter to the connector on the SAS hard drive.
Figure 5-49
3. Install the four silver, ANSI 6–32 guide screws into the hard drive.
ENWW
(Predisassembly procedures on page
(Removing the side access panel on page
Attaching the SAS-SATA adapter to the SAS hard drive
57), and then remove
61).
Removing and replacing components 95