SATA hard drive
For more information about SATA hard drives and SATA RAID configurations, see
devices on page
This section describes how to remove and install a SATA hard drive.
Removing a SATA hard drive
To remove a SATA hard drive:
1.
Disconnect power from the system
the side access panel
2.
Disconnect the data (1) and power (2) cables from the SATA hard drive.
Figure 5-52
ENWW
146.
(Removing the side access panel on page
Disconnecting the SATA hard drive cables
(Predisassembly procedures on page
Removing and replacing components
Configuring RAID
57), and then remove
61).
97