Power Button Assembly; Removing The Power Button Assembly - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

4. Screw the bracket to the front panel I/O device assembly, and then screw the bracket to the chassis.
5. Connect the front audio cable to the audio connector (1). Connect the front USB cable to the USB
connector (2). Connect the front control panel cable to the control panel connector (3). If an
IEEE-1394 card is installed, connect the front IEEE-1394 cable to the card connector.
Figure 5-15

Power button assembly

This section describes how to remove the power button assembly.

Removing the power button assembly

To remove the power button assembly:
1. Disconnect power from the system
access panel
the front bezel on page
front panel I/O device assembly on page
2. Disconnect the power button assembly cable from the system board.
Figure 5-16
68 Chapter 5 Removal and replacement procedures
Attaching the front panel I/O device assembly cables
(Removing the side access panel on page
65), and then remove the front panel I/O device assembly
Removing the power button assembly cable
(Predisassembly procedures on page
61), remove the front bezel
66).
57), remove the side
(Removing
(Removing the
ENWW