System Board; Removing The System Board - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

3. Align the triangle on the top of the processor with the triangle on the corner of the processor socket,
and then install the processor into the socket. Ensure that the underside of the processor is level
with the top of the processor socket. Close the socket cover and lightly press down on processor
while closing the socket lever.
Figure 5-62

System board

This section describes removing and installing the system board.

Removing the system board

To remove the system board:
1. Disconnect power from the system
access panel
NOTE:
convenience.
2. Remove all expansion boards and graphics cards
Removing a PCI card on page
processor heatsink on page
TIP: Make a note of the cable connections before disconnecting them from the system board.
For more information, refer to
3. Disconnect all cabling from the system board.
ENWW
Seating the processor
(Removing the side access panel on page
Although the processor heatsink can remain in place, you might want to remove it for
80), and then remove the processor heatsink
101).
Power connections to drives on page 86
(Predisassembly procedures on page
61).
(Removing a PCI Express card on page
Removing and replacing components 105
57) and remove the side
78,
(Removing the
.