Sas Hard Drive; Removing A Sas Hard Drive - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

2. Disconnect the power (1) and data (2) cables from the back of the diskette drive.
Figure 5-45
3. Lift the green drive-lock release tab (1) and gently slide the drive out of the chassis at the same
time (2).
Figure 5-46
NOTE: To install a diskette drive, reverse the previous steps. You might need to remove the front bezel
to install the drive.

SAS hard drive

This section describes how to remove and install a SAS hard drive.

Removing a SAS hard drive

1. Disconnect power from the system
the side access panel
ENWW
Disconnecting the diskette drive cables
Removing the diskette drive from chassis
(Predisassembly procedures on page
(Removing the side access panel on page
57), and then remove
61).
Removing and replacing components 93