Installing An Optical Drive (Desktop Configuration) - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

3. Press down on the yellow drive-lock release lever (1) and gently slide the drive out of the chassis
(2).
Figure 5-42
4. After pulling the drive out (1), if you plan to install another drive, remove only the four guide screws
from the drive (2).
Figure 5-43

Installing an optical drive (desktop configuration)

1. Disconnect power from the system
access panel
the front bezel on page
on page
ENWW
Removing the optical drive from chassis
Removing the optical drive screws
(Removing the side access panel on page
65), and then remove the bezel blank
65) where the drive is being added.
(Predisassembly procedures on page
61), remove the front bezel
Removing and replacing components
57), remove the side
(Removing
(Removing bezel blanks
91