Installing A System Processor - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

2. Raise the processor socket lever (1) and open the cover (2).
Figure 5-61
CAUTION:
extreme care when handling the processor.
3. Pull the processor straight out of the socket (3).
CAUTION:
Handle the processor by the edges.
NOTE: Store the processor in a static free container in a safe place where it cannot be damaged.

Installing a system processor

1. Disconnect power from the system
access panel
(Removing the processor heatsink on page
system processor on page
2. Raise the processor socket lever and cover fully.
CAUTION:
extreme care when installing the processor in the socket.
104 Chapter 5 Removal and replacement procedures
Removing the system processor
The processor socket contacts are delicate. To avoid bending the contacts, use
Do not touch the processor socket pins or the gold pads underneath the processor.
(Predisassembly procedures on page
(Removing the side access panel on page
103).
The processor socket contacts are delicate. To avoid bending the contacts, use
61), remove the processor heatsink
101), and then remove the processor
57), remove the side
(Removing a
ENWW