3.
Press in on the clips that secure the power button assembly to the chassis (1).
Figure 5-17
4.
Dislodge the metal clip from the chassis by rocking the power button assembly back and forth, and
then slide the power button assembly out from the front of the chassis (2).
NOTE:
To replace the power button assembly, reverse the previous steps.
System speaker
This section describes how to remove the system speaker.
Removing the system speaker
To remove the system speaker:
1.
Disconnect power from the system
access panel
ENWW
Removing the power button assembly
(Predisassembly procedures on page
(Removing the side access panel on page
57) and remove the side
61).
Removing and replacing components
69