Installing The Front Panel I/O Device Assembly - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

3. Remove the two smaller Torx screws (1) that hold the front panel I/O device assembly and bracket
to the chassis (3).
Figure 5-14
4. Remove the two larger Torx screws (2) that hold the front panel I/O device assembly to the bracket
(3).
5. Separate the bracket from the front panel I/O device assembly.
6. Pull the front panel I/O device assembly out about two inches from the chassis (5).
7. Pull the front panel cables through the chassis and through the front of the workstation. You might
have to slide the cables out one at a time.

Installing the front panel I/O device assembly

To instal the front panel I/O device assembly:
1. Thread each front panel I/O device assembly cable through the same holes from which they were
removed.
2. Push the front panel I/O device assembly into the chassis. Using your fingers, orient the cables so
that there is enough room for the front panel I/O device assembly to easily fit in its slot.
3. Loosely place the bracket on the front panel I/O device assembly and hook the bracket to the
chassis.
ENWW
Removing the front panel I/O device assembly
Removing and replacing components 67