Installing The Front Panel I/O Device Assembly - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Installing the front panel I/O device assembly

To install the front panel I/O device assembly:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2. Remove the access panel (see
3. Remove the front bezel (see
4. Rotate the drive cage to its upright position.
Figure 5-36
5. Carefully guide the front panel I/O device assembly cables through the chassis openings from
which they were removed.
6. Place the front panel I/O device assembly in the chassis, and then install the fastening screw.
98 Chapter 5 Replacing components
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Removing the front bezel on page
Rotating the Drive Cage Up
Predisassembly procedures on page
71).
72).
68.
ENWW