Installing The Front Panel I/O Device Assembly; Power Button Assembly; Removing The Power Button Assembly - HP xw4600 Service And Technical Reference Manual

Installing the front panel I/O device assembly

To instal the front panel I/O device assembly:
1. Thread each front panel I/O device assembly cable through the same holes from which they were
removed.
2. Push the front panel I/O device assembly into the chassis. Using your fingers, orient the cables so
that there is enough room for the front panel I/O device assembly to easily fit in its slot.
3. Loosely place the bracket on the front panel I/O device assembly and hook the bracket to the
chassis.
4. Screw the bracket to the front panel I/O device assembly, and then screw the bracket to the chassis.
5. Connect the front audio cable to the audio connector (1). Connect the front USB cable to the USB
connector (2). Connect the front control panel cable to the control panel connector (3). If an
IEEE-1394 card is installed, connect the front IEEE-1394 cable to the card connector.
Figure 4-15

Power button assembly

This section describes how to remove the power button assembly.

Removing the power button assembly

To remove the power button assembly:
1. Disconnect power from the system
access panel
the front bezel on page
front panel I/O device assembly on page
ENWW
Attaching the front panel I/O device assembly cables
(Removing the side access panel on page
68), and then remove the front panel I/O device assembly
(Predisassembly procedures on page
64), remove the front bezel
69).
Removing and replacing components
58), remove the side
(Removing
(Removing the
71